How to read a peptide sequence
Three-letter and one-letter codes, chain ends, terminal modifications and non-standard residues, explained with examples from the catalogue.
Guide
A certificate of analysis (COA) is a document that reports the tests performed on one specific production lot of a product. This guide describes what a typical peptide COA contains and what to check when reading one. It is general guidance, and it describes what such documents usually include, not any particular supplier's document.
Lot documentation for URS PEPS products will be listed in the Documentation section of each product page once published.
The top of a COA identifies the material and the document itself. Expect to see:
Identity is most often confirmed by mass spectrometry (MS). The COA lists a theoretical (calculated) mass next to the mass observed by the instrument. For larger peptides, the observed value may come from multiply charged ions, which the instrument software converts back to a molecular mass.
When comparing these values, check which mass is quoted (average or monoisotopic) and whether the theoretical value refers to the free peptide or a salt. Our guide to molecular weight and salt forms explains the difference. A close match between observed and theoretical mass confirms that the main component has the expected molecular mass. It cannot, on its own, distinguish between two sequences that happen to have the same mass.
Purity is usually measured by high-performance liquid chromatography (HPLC). The sample is separated on a column, and a detector, typically ultraviolet absorbance at around 214–220 nm for peptides, records each component as a peak in a chromatogram. Purity is commonly reported as the area of the main peak as a percentage of the total peak area.
A few points help when interpreting a purity figure:
Some COAs include further measurements that describe the composition of the solid material:
These are different from HPLC purity. Purity describes the peptide-related components, while peptide content describes how much of the total weight is peptide at all.
Many COAs also list simple physical observations, such as "white to off-white lyophilized powder", and sometimes solubility in a stated solvent. Depending on the product, further tests may appear, such as residual solvents, endotoxin or microbial limits. Each entry should show the specification (the acceptance criterion) and the value found.
A COA describes the lot that was tested at the time it was tested. It is not a general statement about other lots of the same product.